new brake pads issue

carcrazee

Driver
so i got some new brake pads for the rears, i un-tightned the ebrake so theres no tension and wen i took the caliper off i skrewed the caliper pistion back in with that square tool thing, put new pads in put it all back together and the rear brakes are still engaged a little, i know theyre brand new pads and need break in but ive never seen it like this. anybody have some ideas of something ive maybe forgoten to do/did wrong?
 
Last edited:
you are so fucking dumb
you really cant put on brake pads, and make a thread about it?
idont understand how hard is it
 
wats engage a little? do you smell you brakes cooking? Sure you turned the piston all the way in? was the piston very difficult to turn back in? are the sliding pins frozen? did you line up the pins on the pads with the notches in the piston?
 
Lube da slides up, den go take dat shit for a drive, 60mph.brake slams and ebrake pulls. Ull be fine
 
wats engage a little? do you smell you brakes cooking? Sure you turned the piston all the way in? was the piston very difficult to turn back in? are the sliding pins frozen? did you line up the pins on the pads with the notches in the piston?

like wen i go off in 1st gear i feel it pulling slightly, i dont smell it but it got realy hot, i turned the pistion for about a minute so it had to be all the way in lol,and yes everyhting was lined up, ive done brake pads on my car before and its just these dont like my car or somthing

pb&j ill try that too thanks
 
like wen i go off in 1st gear i feel it pulling slightly, i dont smell it but it got realy hot, i turned the pistion for about a minute so it had to be all the way in lol,and yes everyhting was lined up, ive done brake pads on my car before and its just these dont like my car or somthing

pb&j ill try that too thanks

did u see the piston go in?? lots of times pistons get siezed, and just spin and not move. loosen the ebrake completly from the handle. u should try using your brain next time, it helps
 
Back
Top Bottom