Search results

CHECK IF U R GETTING 12V TO IACV WIRE ITS BLK/YELLOW AT THE F9 F10 PLUGS BY THE GAPPING HOLE AND UR BOV DO U HAVE LEAKY INJECTOR ORINGS? WATS UR FPR SET AT...

is it smoking at all? sounds like a vac leak is ur bov leaking at idle?

check fuses.. check the marker lights cause there connected to the same circuit

did u check for codes ...

[/U] :laugh::laugh::laugh::laugh:

at least it wasnt that bad

MAKE SURE THAT THE TIMMING IS SET CORRECTLY FIRST AND FOREMOST THEN SET THE IDLE SPEED.... HAVE CAR UP TO OPERATING TEMP TURN OFF UNPLUG TPS START ENGINE AND SET IDLE SPEED THEN PLUG IN TPS... THIS SHOULD GET U INTO THE CORRECT IDLE SPEED..

good read... :thumbup:

wat codes r u getting wat does the smoke smell like? fuel or no? do a compression test... and a leak down..if possible if all checks out then make sure maf is getting proper volts etc blk/wht..12volts.. wht....0.5 volt frm ecu blk...ground... if it is change out maf...

:lolmeme::lolmeme::lolmeme::lolmeme:

:runaway::runaway::runaway::runaway:

:applause::applause::applause::applause::applause: at least we only got zombies here.... Colorado..must have some bad shit in the water..

tru ka love to do this

If you take out the thermostat then the motor will never warm up.... :hmmm:............... :facepalm:

vendor info????

:rockon::rockon::rockon::rockon::rockon::rockon::rockon::rockon::rockon::rockon::rockon:

it wasnt ur sensor paul it was the harness and i had to replace plug a solder it...

wth i felt the same way.. but regaurdless its little dude drifting like a fuking champ... albiet a wheelchair... he got mad skills... i think they should add this to the handi cripple olympics and put real fd drivers in wheel chairs to compete.. and have it benifit a foundation for special...

check voltage to fuel pump ign coil and dizzy.. check for codes... check all the other stuff erybody said too.... or pay me to fix it...:shady::shady::shady::shady:

updates... any vendor info....i got a booth..ready for setup lmk