Search results

POST UM UP ! ! ! ! ! .

XDC Orlando - Hello on Vimeo

.

JB Films on Vimeo

and a little bit of footage... YouTube- charlotte county speedway nov.8 2009

On the dyno we played with turning the boost up on stock everything and at around 12psi it seemed to max out the maf (it pulled timing and cut power) anyone have this problem? I figured id be able to run a tad bit more boost than that.. Time for an N62 maf?

Ok i rubbed through some wiring one night out sliding but didnt break any wires and my tach and speedo dont work, and the gas gauge reads wayyyy past full. So i taped everything up and ziptied it out of the way and it still doesnt work.. any ideas of what is going on?

Last night i went out sliding.. Just hit a couple round-abouts and things; everything was fine. So then we went back to my buddies house and rode out to a meet everything was fine.. drove probably 25 minutes back toward my house and about a mile from my house i heard a tapping noise.. so i baby...

hey guys im going to be running an AEM FIC on my rb25 and i need to know if the crank angle sensor and cam angle sensor is either hall or mag type.. lmk thanks

YouTube - Project D drifting doesnt seem that im pressive.. idk

ok guys ive had 3 s13's with sr20's and im building this one for a buddy. Ive seen the motor run in another car just before we pulled it. I did the wiring, it has spark and fuel which leads me to believe that its timing but ive set the timing at least 5 times now setting the motor to TDC and...

last night i went sliding with my buddy and we were just doing circles and i couldnt even get half a circle before the car would just lose all power, i would pump the gas... nothing and then once it went back to idle it would drive just fine... has anyone had this problem with their FC? oh and...

i put an s14 sr in my base model s13 and im not getting spark... anyone with any suggedtions?

i have an s14sr tranny that is off the motor and i put a shifter in it this morning to see if it was good and it would only go into 5th and reverse and wouldnt travel to the left in neutral.. so i unbolted the tranny from the bell housing and now it wont go into any gear i didnt mess with...