Clearing the caliper...

[Slide~Or~Die]

I was wonderin if any of u guys in the community new if i would be able to clear the caliper on a 350z....with a 18x9 0 offset and a 18x11 +13 offset in the rear.....Thnx guys:bigthumbu


The rims r the Work Equipe.

also if you could maybe point me into a direction to where where i oculd maybe find these rims......besides rbwheels.com
thnx

Hello,

This wheel is called WORK Equip DDC.

This wheel has long been discontinued.

If you were to find them in the used wheel market in the size and offset you shown below. The fit for 350Z is ok, but will require some fender rolling.

Good luck.

Thank you,



thats from work themselves.....but if anyone else is looking for this info u can reffer them here=]

 

[slide-ways-for-five-days]

all depends on mounting face size.

 

[FlyingAngle]

^^^ What he said, all depends on the disk. I not sure about equips but I think it's sometimes stamped on the back of the face somewhere. Also with the DDC the barrel is different where it's bolted together, like so

 

[WhiteWarrenGee]

Cut the lips of a Z out before you even think of rolling.

Good Luck