Fuel Injectors

are u planning on using them again?

no-take the caps off the top(two phillip screws) and then take a rubber mallet and knock them out

yes-take the caps off the top(two phillip screws) uses vise grips to grap on the side of the (red plastic) and pullup hard to pop them out. it always works for me!!!
 
Thanks Bro But How Do I Remove The Phillips Screws. They Are Sooooooo Fucking Tight. All I'm Doing Is Eating The Screw.
 
240MANSX said:
Thanks Bro But How Do I Remove The Phillips Screws. They Are Sooooooo Fucking Tight. All I'm Doing Is Eating The Screw.
Click to expand...

try vice grips on the outside of the screw to break it loose.

and use vice grips on the outside\top of the square suface, rotate the injector while its in the rail. That will break the seal that the o-rings have with the rail so they will slide out.

I break the injector caps loose with the rail installed on the intake manifold so it dose not move.
 
I Replaced Fuel Injector 3 And 4 And Spark Plugs And Cables And Pistons 3 And 4 Are Dead. I Unplug The Injector And Cables Abd Only 1 And 2 Have An Effect But When I Unplug 3 Or 4 The Engine Acts The Same. The Pistons Is Getting Gas, Air And Spark. Why Is 3 And 4 Dead????????????????
 
240SicknessX said:
try vice grips on the outside of the screw to break it loose.

and use vice grips on the outside\top of the square suface, rotate the injector while its in the rail. That will break the seal that the o-rings have with the rail so they will slide out.

I break the injector caps loose with the rail installed on the intake manifold so it dose not move.
Click to expand...

VICE GRIPS WORKED GREAT. THANKS
 
You must log in or register to reply here.
Back
Top Bottom