Tips On Rolling Fender

2

240MANSX

Member
I Would Like To Roll My Rear Fenders. They Keep Eating My Tire. Can Anyone Give Me A Couple Of Tips Or Ideas I Could Use.
 
use a bat or a large metal pipe and stick it between your tire and fender and roll your car back and fourth so that the bat/tube will roll betwwen the tire and fender. this should bend your fender out some and give you that needed clearence. that is the ghetto way. if u need it done right u need to get in contact with someone that has a professional fender roller.
 
all you guys with your fancy rollers to bend that inner lip under.

heres a tip, make sure your 1\4 panel dose not have any bondo on it before you attempt this, and have an experienced individual perform the task.

you wouldnt want to experiment on your own car and see if you could do it yourself. :ugh:
 
Last edited:
if i was you i would get some one who has done it already................. ask them to help you or go to a drift meet and ask some one there to help you but you will need a heat gun a metal pole 3-4 inch wide to roll the fender but you might end up chiping the paint if you do it you'r self ................................good luck man it's easy you could do it i did it for my brothers ford EXploder easy stufffffff
 
ive rolled quit a few sets of fenders i did about 20 porsche 996 and 993 cars.. with a professional roller.. man those cars are easy ...
240's on the otherhand are a fucking bitch

my advise to you is go slow use a heat gun to heat the paint up and make it pliable and get/rent a good fender roller.. oh and dont use to much up angle on the roller wheel i hate when they flare out and up .. it looks gay and is useless
 
You must log in or register to reply here.
Back
Top Bottom