While installing my PBM coilovers..... me like an idiot without a torque wrench, overtightened one of the two bolts/threads for the rear coilover top hat:chair: So my question is how would i go about fixing this cause i snapped soo much thread off i cant even use another bolt to put on what lil bit of thread is left... help would be appreciated!!
Im an idiot (suspenshion help)
- Thread starter Bogues234
- Start date
Hammer out the old snapped stud, and replace it? And you don't need a torque wrench bro. I know common sense is rare these days but c' on son.
Sketchy564
Driver
well you spelled suspension wrong, so i believe the title
and depending on how bad it is, you should be able to use a tap and die kit to re-thread it.... good luck
and depending on how bad it is, you should be able to use a tap and die kit to re-thread it.... good luck
He says he "snapped" it^ not cross-threaded it
ok where do i get the replacement stud?
Living4surf
Driver
Just get a bolt and put it through the hole offer you hammer out the old one
pms13
Driver
i was wondering when this idea was gonna come up. that was the first thing i thought of when i finish reading his post.
